[−][src]Module app::touch_sensor

Structs

TouchEventInfo	Touch Event Info for multiple touches. Based on https://github.com/lupyuen/hynitron_i2c_cst0xxse/blob/master/cst0xx_core.h#L104-L115
TouchInfo	Touch Info for a single touch. Based on https://github.com/lupyuen/hynitron_i2c_cst0xxse/blob/master/cst0xx_core.h#L104-L115

CFG_MAX_TOUCH_POINTS	Max touch points for the touch controller
FT_TOUCH_POINT_NUM
HYN_MAX_ID
HYN_MAX_POINTS	Max touch channels for the touch controller
HYN_TOUCH_EVENT_POS
HYN_TOUCH_ID_POS
HYN_TOUCH_MISC
HYN_TOUCH_STEP
HYN_TOUCH_XY_POS
HYN_TOUCH_X_H_POS
HYN_TOUCH_X_L_POS
HYN_TOUCH_Y_H_POS
HYN_TOUCH_Y_L_POS
POINT_READ_BUF
TOUCH_CONTROLLER_ADDRESS	Touch Controller I2C Address: https://github.com/lupyuen/hynitron_i2c_cst0xxse
TOUCH_INTERRUPT_PIN	Interrupt Pin for touch controller. We listen for the touch controller interrupt and trigger an event.
TOUCH_RESET_PIN	Reset Pin for touch controller. Note: NFC antenna pins must be reassigned as GPIO pins for this to work.

BUF	Buffer for raw touch data
I2C_DATA	I2C packet to be sent
I2C_BUFFER	Buffer containing I2C read/write data
TOUCH_DATA	Touch data will be populated here
TOUCH_DELAY
TOUCH_EVENT	Event that will be forwarded to the Event Queue when a touch interrupt is triggered
TOUCH_RESET	Reset GPIO Pin

probe	Probe the I2C bus to discover I2C devices
read_register	Read the I2C register for the specified I2C address (7-bit address)
read_register_range	Read a range of I2C registers from the I2C address `addr` (7-bit address), starting at `start_register` for count `num_registers`. Save into `buffer`.
read_touchdata	Read touch controller data. This only works when the screen has been tapped and the touch controller wakes up. Ported from https://github.com/lupyuen/hynitron_i2c_cst0xxse/blob/master/cst0xx_core.c#L407-L466
start_touch_sensor	Initialise the touch controller. NFC antenna pins must already be reassigned as GPIO pins: Set `NFC_PINS_AS_GPIO: 1` in hw/bsp/nrf52/syscfg.yml. To check whether whether NFC antenna pins have been correctly reassigned as GPIO pins, use the `nrf52` crate and check that the output is `fe`:
test	Test reading some registers for I2C devices
touch_event_callback	Callback for the touch event that is triggered when a touch is detected
touch_interrupt_handler	Interrupt handler for the touch controller, triggered when a touch is detected

MynewtDelay
MynewtGPIO